SkyLink 91562-01 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para motociclos SkyLink 91562-01. SkyLink 91562-01 User's Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 16
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
-J02028 REV. 2010-09-07
REMOTE CONTROL GARAGE DOOR OPENER KITS
GENERAL
Kit Numbers
91558-01A (Transmitter/Receiver Kit), 91561-01 (Transmitter
Kit), 91562-01 (Receiver Kit)
Models
For model fitment information, see the P&A retail catalog or
the Parts and Accessories section of www.harley-davidson.com
(English only).
Additional Parts Required
2011 and later Softail models will require separate purchase
of an Electrical Connection Harness (Part No. 72673-11).
Tools and Supplies Required
Electrical Contact Lube (Part No. 99861-02) or equivalent is
required after battery cable disconnection.This item is available
from a Harley-Davidson dealer.
The rider's safety depends upon the correct installation
of this kit. Use the appropriate service manual procedures.
If the procedure is not within your capabilities or you do
not have the correct tools, have a Harley-Davidson dealer
perform the installation. Improper installation of this kit
could result in death or serious injury. (00333a)
NOTE
This instruction sheet refers to service manual information. A
service manual for this year/model motorcycle is required for
this installation and is available from a Harley-Davidson dealer.
Electrical Overload
It is possible to overload your vehicle's charging system
by adding too many electrical accessories. If the combined
electrical accessories operating at any one time consume
more electrical current than the vehicle's charging system
can produce, the electrical consumption can discharge
the battery and cause damage to the vehicle's electrical
system. See an authorized Harley-Davidson dealer for
advice about the amount of current consumed by addi-
tional electrical accessories or for necessary wiring
changes. (00211c)
When installing any electrical accessory, be certain not
to exceed the maximum amperage rating of the fuse or
circuit breaker protecting the affected circuit being modi-
fied. Exceeding the maximum amperage can lead to elec-
trical failures, which could result in death or serious injury.
(00310a)
The Remote Control Transmitter in kits 91558-01A and 91561-
01 requires up to 0.5 Amps additional current from the electrical
system.
Kit Contents
See Figure 27, Table 1, Table 2 and Table 3.
FCC NOTICES
NOTE
Changes or modifications to this unit not expressly approved
by the manufacturer could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the
limits for Class B digital devices pursuant to Part 15, Subpart
B of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a resid-
ential environment. This equipment generates, uses, and can
radiate radio-frequency energy, and if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the distance between the equipment and the
receiver.
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
-J02028 1 of 16
Vista de página 0
1 2 3 4 5 6 ... 15 16

Resumo do Conteúdo

Página 1 - FCC NOTICES

-J02028 REV. 2010-09-07REMOTE CONTROL GARAGE DOOR OPENER KITSGENERALKit Numbers91558-01A (Transmitter/Receiver Kit), 91561-01 (TransmitterKit), 9156

Página 2 - VEHICLE PREPARATION

5. Pull only the orange/white wire out of the longer piece ofconduit on the garage door opener wire harness. Cut theexcess length from the orange/whit

Página 3 - TRANSMITTER INSTALLATION

NOTEOn some Sportster models the ignition module must beremoved to access the orange/white wire in the main harness.1. See Figure 20. Carefully slice

Página 4 - 1994-2003 Sportster Models

1is067311. Headlamp connector [38]Figure 23.Wire Splice Locations (2005 and Later V-Rod)YELLOW AND WHITE LEAD CONNECTIONSTO HEADLAMPDyna Models1. See

Página 5 - FLHR Touring Models

21is067271. White and yellow headlamp wires2. Cut headlamp wire casing to access wiresFigure 25.White and Yellow Wire Optional External SpliceLocation

Página 6 - 2007 and Later V-Rod Models

RECEIVER AND TRANSMITTERPROGRAMMINGAfter the receiver and transmitter are installed, the receivermust be programmed to receive the transmitter frequen

Página 7 - HARNESS CONNECTION

SERVICE PARTS2b 2a38641751410111513129is06735Figure 27. Service Parts, Remote Control Garage Door Opener KitsTable 1. Service Parts, Garage Door Opene

Página 8 - Dyna Models

SERVICE PARTSTable 2. Service Parts,Transmitter Kit 91561-01Part NumberDescription (Quantity)ItemNot sold separatelyTransmitter assembly191650-01Hardw

Página 9 - SWITCHED POWER SOURCE

RECEIVER INSTALLATIONKits 91558-01A and 91562-01 only1. Unplug the power cord from the garage door drive unit toprevent door activation during install

Página 10 - Sportster Models

For Dyna, Softail and Sportster models:When servicing the fuel system, do not smoke or allowopen flame or sparks in the vicinity. Gasoline is extremel

Página 11 - 2005 and Later V-Rod Models

2000 and Later Softails, Except Deuce (FXSTD)1. Remove the fuel tank mounting bolts. See the correctsection (Carbureted or EFI Engine) of the service

Página 12 - TO HEADLAMP

312is067151. Transmitter mounting location2. Wires to headlamp3. Ignition moduleFigure 7.Transmitter Mounting and Wire Routing, (2003or Earlier Sports

Página 13 - V-Rod Models

156234is067181. Mount transmitter to fairing2. Headlamp connector3. Orange/white wire4. Black wire5. White wire6. Yellow wireFigure 10.Wires for Trans

Página 14 - PROGRAMMING

HARNESS CONNECTIONGeneralSplicing of wire leads is necessary in the installation of thegarage door opener to the vehicle. Find the instructions for as

Página 15 - SERVICE PARTS

123is02055a1. 1 into 1 splice2. 2 into 1 splice3. 3 into 1 spliceFigure 15. Splice ConfigurationsNOTEElectrical connectors are identified in the servi

Página 16

11is011031. Ground screws (black wire)Figure 16. Ground Connections (Sportster Models)2002-2003 V-Rod Models1. Cut the black transmitter ground wire t

Comentários a estes Manuais

Sem comentários