Skylink TOTAL PROTECTION SC-100 Manual do Utilizador

Total Protection Alarm SystemMODEL: SC-100www.skylinkhome.comCUSTOMER SERVICE17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3Tel : (800) 304-1187F

–10––23–INSTALLATIONAfter mounting the sensor at the desired location, it isimportant to perform a walk test in order to determineif the sensor is det

–11––22–Before you learn how to use your security system, test to make sure that the door/window sensors and the motion sensor are communicating with

–12––21–If you make a mistake while programming, the Control Panel emits three shortbeeps. That means the system has cleared and you must start the p

–13––20–Now that the system is installed and the sensors are communicating with theControl Panel, it is time to learn how to do basic programming of y

–14––19–STANDARD PROGRAMMINGYou hear a long beep. The arm light and the red lights in zones 3 and 4 go on.Both the green and red lights flash in zone

–18––15–TO ARM SYSTEM USING THE KEYCHAIN TRANSMITTERThere are 2 different arm options to choose from:1. Press button #1, and the Control Panel will b

–16––17–KEYCHAIN TRANSMITTER (4B-434)TO DISARM THE SYSTEM, OR DEACTIVATE THE SIREN USING THEKEYCHAIN TRANSMITTERWhen the system is armed:Press button

–2–SKYLINK TECHNOLOGIES INC.Your Guide to theTotal Protection Alarm SystemMODEL: SC-100The SC-100 Total Protection Alarm System contains all the above

–3–PACKAGE CONTENTS... 4OVERVIEW...

Audio Alarm (AA-433)- Additional indoor/outdoor siren- Water resistant- 110 dB siren with flashing LED- Operates by AC adapter with 9V alkaline back

–5––28–OVERVIEWCongratulations!You have just purchased one of the most reliable and up-to-date wireless securitysystems on the market today. Skylink i

–6––27–PLANNING YOUR HOME SECURITY NEEDSYou may choose to install a motion sensor to protect any valuables such asantiques or paintings. Point the mot

–7––26–The Control Panel, door/window sensors and the motion sensor are installedusing the screws included. We have also included double sided tape, (

–8––25–1. Position the transmitter be-side the door/window frame onthe wall using either two sidedtape or screws. If you are usingscrews, first pry of

–9––24–INSTALLATION2. Position the magnetic switch connected tothe transmitter on the door/window frame.3. Position the magnet on the door beside them