SkyLink HA-400 Manual do Utilizador descarregar pdf (Página 3)

8. OTHER HOUSEHOLD ALERT

SENSORS

The Household Alert

Long Range Receiver can work with up to 4

sensors: garage door monitor sensor, door / window sensor,

water sensor, indoor/outdoor motion sensor, etc. Please visit

www.skylinkhome.com or contact us at support@skylinkhome.com for

more information of how to fully utilize your Wireless Motion Alert.

6. OPERATION (CONT)

When the battery level on the sensor drops to a certain level, or the

sensor is out of the operating range, the receiver will show a “loss of

signal” indication. The red LED representing that zone will

rapidly,

i.e. if zone 1 sensor is lost, the zone 1 red LED will

rapidly.

When the loss of signal indication occurs, move the receiver closer to the

corresponding sensor and trigger that sensor. If the red LED stops

ing rapidly, that means the receiver or sensor needs to be relocated. If the

“loss of signal” indication persists, replace the battery of that sensor.

7. LOSS OF SIGNAL INDICATION

10. WARRANTY

If, within one year from date of purchase, this product should become defective

(except battery), due to faulty workmanship or materials, it will be repaired or

replaced, without charge. Proof of purchase and a Return Authorization are required.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

WARNING:

Changes or

to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. I

f this equi pment dose cause harmful interference to radio or television

reception, which can be determined by turning the equipment

and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the

separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit

from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

9. FCC

CUSTOMER SERVICE

17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3

Email:support@skylinkhome.com

http://www.skylinkhome.com

P/N. 101Z756

If you would like to order Skylink’s products or have getting them to

work or download information and user manual, please :

1. visit our FAQ section at

www.skylinkhome.com, or

2. email us at

[email protected], or

3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.

Fax (800) 286-1320

11. CUSTOMER SERVICE

Mute

When a sensor is triggered for a long period of time, you may stop the

buzzer by pressing the mute button. When another signal comes again,

you can disable the buzzer for all currently activated sensors by pressing

the mute button. The receive will beep again if it receives another signal.

For instance, if you are working in your

garage, you may want to disable the

buzzer for this garage only. Then you can

press the “Mute” button after it starts to

sound. If any other sensor is triggered,

the receiver will sound again.

Alarm

When the receiver is in Alarm operation mode, it will sound its siren

when a sensor is activated. The maximum alarm duration is set for 3

minutes. To terminate the siren during the 3-min interval, press the mute

button. Although the alarm siren is terminated, if that sensor is still

activated, its corresponding LED will continue to

Note: This audio siren is not intended to prevent intruder break-in, it is

rather an alert signal indicating a sensor is activated. Therefore,

turning

the siren does not require password.

No audio will be emitted even sensor is a ctivated. Only zone LED will .

Page 3 of 3

1 2 3

Comentários a estes Manuais

Sem comentários

SkyLink HA-400 Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com não SkyLink HA-400